Emergency Survival Tent
Compact, heat-reflective emergency shelter for fast deployment when conditions change unexpectedly. Use this guide to inspect the kit, choose a safer site, set the ridgeline, maintain ventilation and repack the shelter correctly.
01 Before You Need It
Inspect, Know & PackA 60-second check before each trip makes the shelter faster to use when it matters.
- Tent film. Check for tears, punctures, brittle areas or damaged seams.
- Paracord. Confirm the full 20 ft (6 m) cord is packed and free of major cuts or fraying.
- Whistle and carry sack. Keep both with the shelter so the kit stays complete.
What's Included
- 1 x heat-reflective waterproof tube tent
- 20 ft (6 m) paracord
- Emergency whistle
- Reinforced carry / stuff sack
Specifications
Capacity: 2 adults
Material: Heat-reflective waterproof laminate
Unpacked: 160 x 208 cm (63 x 82 in)
Packed: 9 x 14 cm (3.5 x 5.5 in)
Weight: 240 g (8.5 oz)
Exterior: High-visibility orange
02 Quick Setup
5 StepsSelect two sturdy anchor points roughly 8-15 ft apart. Avoid drainage paths, low ground and overhead hazards.
Remove the shelter and paracord. Clear sharp rocks, sticks and debris from the ground.
Run the paracord through the tube tent from end to end.
Secure the cord to both anchor points about 3-4 ft above the ground and tension it so the shelter hangs taut.
Weight the lower edges with rocks, logs or gear. Keep an opening for fresh airflow and position the opening away from the wind.
Never fully seal the shelter around occupants. Always maintain an opening for fresh airflow.
03 Use for Warmth & Site Selection
Position With PurposeCold Conditions
- Keep the reflective silver surface facing inward toward occupants.
- Reduce direct wind exposure by placing the opening on the leeward side.
- Use dry insulation beneath you when available.
Site Selection
- Avoid low ground, dry creek beds and drainage paths.
- Clear sharp rocks, sticks and debris before setting up.
- If trees are unavailable, stable trekking poles or a pack may help support a makeshift ridgeline.
In an emergency, the shelter may be wrapped around the body with the reflective side inward as a temporary bivy-style cover. Keep the face and an airflow opening unobstructed.
04 Care, Cleaning & Storage
Dry Before Packing- Clean gently. Wipe with a damp cloth. Avoid harsh chemicals, solvents and abrasive scrubbing.
- Dry completely. Air dry before repacking to reduce odor and moisture damage.
- Store protected. Keep in a cool, dry place away from direct sunlight and extreme heat.
- Inspect regularly. Check after use and periodically for pinholes, tears, brittleness or damaged reflective surfaces.
- Repair or replace. Patch small tears with suitable waterproof repair tape. Replace a badly damaged shelter before relying on it again.
05 Important Safety
Emergency Shelter OnlyDesigned as temporary emergency shelter, not as a replacement for a full camping tent on planned trips.
Reflective film can melt or burn. Keep the shelter well away from campfires, stoves, sparks and other heat sources.
Never fully seal occupants inside. Maintain a fresh-air opening and keep the face unobstructed.
Paracord and thin shelter film can create entanglement or suffocation hazards. Keep away from small children unless closely supervised.
06 Troubleshooting
Fast FixesConfirm the film is intact, the paracord is present, a ventilation opening can be maintained and the setup is well clear of flame, sparks and other heat sources.
Contact the APEX team at info@apexproseries.com.